Transparent Conductors and the Rise of the Nanomaterials
Home >> Product Reviews >> Consumer Electronics >> Transparent Conductors and the Rise of the Nanomaterials

Transparent Conductors and the Rise of the Nanomaterials

Published by: John D. (1)
Word Count: 574 | Comments: 0 | Article Views: 203 | Share this article on

When NanoMarkets first started providing analysis of the transparent conductor (TC) industry, some six years or so ago, the industry was easy to characterize.  ITO ruled the roost, except where the market was looking for especially low-cost solutions; in antistatic applications.   True, executives in the display industry – and even in the transparent conductor industry itself – knew all the unkind things to say about ITO.  It cracked, it cost a lot, even that it had a yellowish tinge, etc., etc.

When one examined at the alternatives, ITO began to look pretty good.  None of them could compete with ITO on the crucial transparency and conductivity parameters.  In any case, most of the alternatives to ITO were not ready for prime time; at best they were in that limbo phase called sampling.  The threat to ITO from its rivals was negligible.

The one exception to this rule was in the thin-film PV (TFPV) application, where alternative transparent conducting oxides (TCOs) quickly made their mark.  First Solar the dominant supplier has adopted FTO as its transparent conductor, while most of the firms in the CIGS space use AZO.  In the a-Si PV sector, FTO and AZO are also used.  As an aside, there is an important takeaway from all this.  Applications that are relatively new – such as TFPV – are more likely to adopt new TCs.  By contrast consider the conventional – and highly established -- LCD industry, which continues to demonstrate considerable reluctance to ITO alternatives.

While the use of TCOs other than ITO in the TFPV industry is proof positive that, ITO doesn’t always get to win; it hardly represented a paradigm shift.  It was, after all, a just a switch from one TCO to another.  In the past year to two years, we have seen something genuinely new in the TC space; the rise of the nanomaterials.

Nano-TCs:  More Firms, More Materials, More Applications

By rise, we have in mind three things.  First, while there have been firms around developing nanomaterial approaches to rival ITO, there are now a lot more such firms and they appear to have been quite successful in attracting capital.  Second, there is now considerable diversity in the nanomaterials being offered in this sector.  A few years back nanomaterial challenges to ITO consisted entirely of carbon nanotube inks.  Take a look at this space now and you will also see silver nanostructures in solution, silver grids, copper-based solutions and graphene.  As NanoMarkets discusses in its upcoming report, we would not be surprised to see nanostructured polymers also enter this fray.

The third aspect of the rise of the nanomaterials materials that needs to be considered is that some of these materials might now reasonably be considers to be commercialized.  True, some of these materials remain well within the lab, but some are out there is products that you can buy now.  One of the important messages that have come out of the interview program that NanoMarkets has just completed with manufacturers of TCs is that several nanomaterials are now commercialized.  They are being used in a very small number of products and often in limited quantities.  But in the past year they have crossed an important barrier.

John D. - About the Author:

John D. is a well known writer with more than 8 yrs of experience in writing Renewable Energy and Electronics article, blog and books. Presently works with NanoMarkets, which is a leading provider of market research and industry analysis of opportunities within advanced materials and emerging energy and electronics markets.! For More Info:

* Required fields
Type the characters you see in the picture below.*